5.4 Liter belt diagram

Here is the 5.4 Liter belt diagram by popular demand. Engine belt noise is a common complaint on many vehicles and many different engines. The Ford 5.4 L engine is no different in this respect. 
5.4 L engine belt diagram

5.4 L engine belt diagrams
Ford came out with some tactics to help technicians deal with this common problem. Please take a minute to read them before installing a new part on your engine.

There are many causes that can force serpentine belts to become noisy. Sometimes this is due to pulley misalignment or even a wobbling accessory pulley. Also incorrect alignment of the drive belt can result in noise and premature wear.

A good trick for determining proper belt alignment would be to take a straight edge and place it in the grooves of the Pulley. You have to make sure that you are in the same grooves on each accessory. Even slight misalignment’s will show up using this method.

Do not use belt dressing

Ford and other engine manufacturers do not recommend that you apply any types of fluids to the belts and this includes belt dressing or any other type of spray lubricant. These may solve the problem temporarily but can lead to the noise returning with a vengeance.

Often these belt dressings will start to break down the rubber on the belt and replacement will be needed. These engine belt noises can be intermittent or constant noise. Often this occurs when the drive belt slips on an accessory Pulley under heavy load conditions.

Engine belt dressing may increase the slipping but silence the noise because it is considered a lubricant. Use the above 5.4 Liter belt diagram to replace the serpentine belt instead of spraying belt dressings all over the old one.

5.4 Liter belt noise

5.4 Liter AC Compressor

5.4L Compressor

Sometimes a serpentine belt may seem that it is noisy but is actually being caused by one of the accessories that it drives. An example would be if an AC system is overcharged the belt may slip over the compressor drive pulley.

Also in the case of an alternator or another accessory that has a worn sticking or even seized bearing can cause the belt to slip over the top of the Pulley instead of rotating the accessory properly.

Also fluid leakage onto the drive belt may cause the same condition where the belt will slip over the accessory instead of driving it properly. Most often you will see this with the water pump.  Sometimes the 5.4 Liter engine will get a slow leak from the water pump and as the pulley rotates it sprays on to the belt.


Often if the original belt didn’t make any noise and was replaced due to regular maintenance if the replacement unit becomes noisy the correct size of the belt should be checked. Often I have seen an incorrect replacement belt cause this kind of noise.

When the accessory drive belt is too long this will allow the belt tensioner, number 7 in the 5.4 Liter belt diagram above, to be pulled all the way to the travel stop. This may cause an incorrect tension and allow for slipping condition that causes nasty belt noise.

The Ford engine belt tensioner has an indicator that shows a normal range of operation. If this indicator is out of this range this is a sure sign that either the belt has stretched excessively or the wrong part has been installed. You should also check that the tensioner has smooth operation and is not binding or sticking when you rotate it.

Additional engines are covered on my drive belt diagrams page.

See the latest posts on this car repair Faq blog. This next link takes you from 5.4 liter belt diagram to the blog homepage.

One comment

Leave a Reply

Your email address will not be published. Required fields are marked *